Polaris 2012 RANGER RZR 570 INTL Service Manual page 266

FINAL DRIVE
8. Check the action of the torsion spring by rotating in
both directions to ensure the spring and retainer are
installed properly.
9. Be sure the armature plate tabs are fully engaged into
the ro ll ca ge asse mbly a nd a re re sting on th e cut-
grooves of the ring gear.
NOTE: Verify armature plate tabs are in the slots on
the roll cage and are resting in the ring gear grooves.
10. Carefully install the ring gear and roll cage assembly
into the gearcase housing.
7.24
Engage
Tabs
9923523 - 2012 RANGER RZR 570 Service Manual
© Copyright 2011 Polaris Sales Inc.
11. Install a new O-ring on the cover plate assembly.
NOTE: Be su re the sq uare O-ring is p laced f lat on
the c over s urface. If th e O- ring i s t wisted f luid
leakage may occur.
12. Carefully install the LH output hub assembly into the
cover plate. Take care not to damage the new cover
plate seal while installing the output hub.
13. Install the output cover assembly onto the gearcase
housing. Install the (7) cover plate screws and torque
to specification.
Cover Plate Screws:
7-11 ft. lbs. (10-15 Nm)
LH Hub
Torque Screws
= T