Polaris 2012 RANGER RZR 570 INTL Service Manual page 31

3. If needed, start the engine and allow it to idle for three
minutes until warm. Stop the engine.
4. Place a d rain pa n b eneath e ngine cr ankcase a nd
remove the drain plug.
Drain Plug
CAUTION
Oil may be hot. Do not allow hot oil to come into
contact with skin, as serious burns may result.
5. Allow oil to drain completely.
6. Replace sealing washer on drain plug.
NOTE: The sealing surface on the drain plug should
be clean and free of burrs, nicks or scratches.
7. Reinstall drain plug and torque to 12 ft. lbs. (16 Nm).
8. Place a drain pan under vehicle below the oil filter.
9. Place shop towels beneath oil filter. U sing Oil Filter
Wrench (PU-50105) and a 3/8" extension, turn the oil
filter counter-clockwise to remove it.
10. Using a clean dry cloth, clean filter sealing surface on
the crankcase.
NOTE: Drain plug is accessed
through the skid plate.
Oil Filter
9923523 - RANGER RZR 570 Service Manual
© Copyright 2011 Polaris Sales Inc.
11. Lubricate O-ring on n ew filter with a film o f fre sh
engine oil. Check to make sure the O-ring is in good
condition.
12. Install new filter an d tur n b y hand u ntil filter gasket
contacts the sealing surface, then turn an additional
1/2 turn.
13. Remove the engine o il dipstick (see "Eng ine Oil
Level").
14. Using a long funnel, fill the sump with 2 qts. (1.9 l) of
PS-4 Plus Synthetic Engine Oil (2876244).
Crankcase Drain Plug Torque:
12 ft. lbs. (16 Nm)
Oil Filter Torque:
Turn by hand until filter gasket contacts sealing
surface, then turn an additional 1/2 turn
Oil Filter Wrench:
PU-50105: 2.5" (64 mm)
15. Verify the transmission is still positioned in PARK (P).
16. Start the engine and let it idle for two minutes.
17. Stop the engine and inspect for leaks.
18. Re-check the oil level on the dipstick and add oil as
necessary to bring the level to the upper mark on the
dipstick.
19. Dispose of used oil and oil filter properly.
MAINTENANCE
= T
2.17
2