Settings To Be Specified In Advance; Network Setting; Registering And Specifying Destinations - Oce CM5520 User Manual

1
1.3

Settings to be specified in advance

It is recommended that the settings described below be specified before us-
ing the network scanning functions. The settings described in "Network Set-
ting" must be specified, and any other settings should be specified as
necessary.
!
Detail
For details on specifying network settings, refer to the sections listed be-
low.
"Network Settings" on page 4-2
User's Guide [Web Connection Operations]

Network Setting

An IP address must be assigned to the machine and settings, such as the
SMTP server, must be specified in order to use the machine on the network.
Be sure to specify these settings.
Settings can be specified by using the machine's touch panel or by using
Web Connection from a Web browser on a computer on the network.

Registering and specifying destinations

The destinations (recipients) for scan data can be registered in either of the
following ways.
- Using the touch panel of the machine
- Using Web Connection from a computer on the network
The following destinations can be registered.
Type
Address book
destinations
Group destinations
Note
A destination can also be entered from the machine's touch panel before
scanning, even if the destination has not been registered in advance. This
is called "direct input". For details, refer to "Entering addresses directly"
on page 2-25.
1-8
Description
A single destination is assigned a single registration number.
Multiple destinations can be registered together. In addition, E-mail,
FTP, SMB, and user box destinations can be registered together in
a single group.
Before using scanning functions
cm5520