Ftp - Oce CM5520 User Manual

Specifying Utility mode parameters
!
Detail
To check a registered destination, select it, and then touch [Check Job
Set.].
To change the settings for a registered destination, select it, and then
touch [Edit]. The registration number cannot be changed in the Edit
screen.
To delete a registered destination, select it, and then touch [Delete].
If the computers or workgroups on the network (subnet) that this machine
belongs to is more than the numbers listed below, browsing over the net-
work may not be performed correctly.
Workgroups: 128
Computers: 128
Note
The registration cannot be completed if no settings are specified for
"Name", "Host Address" and "File Path".
To cancel the registration, touch [Cancel].
To finish specifying settings in the Utility mode, press the [Utility/Counter]
key. Otherwise, exit the Utility mode by touching [Close] in each screen
until the screen for the Copy, Fax/Scan or Box mode appears.

FTP

Settings can be specified for the following for the FTP destination to be reg-
istered.
Parameter
No.
Name
Index
Host Address
File Path
cm5520
Description
Type in the registration number (between 1 and 2000) for the address book
destination. When the screen appears, the displayed number is the lowest
available number.
Type in a name of 24 characters or less for the registered destination.
Select the index characters. For frequently used destinations, touch [Fa-
vorites] so that the destination can be found more easily.
Type in the host address in the format of a host name, IPv4 address or IPv6
address.
For a host name, type in 63 characters or less.
Type in 96 characters or less for the path to the saved file.
3
3-19