Honda 2000 XR50R Service Manual page 70

ENGINE REMOVAL/INSTALLATION
-engine hanger nuts and washers
Place the floor jack or other adjustable support
under the engine.
Remove the hanger bolts and the engine from the
frame.
CAUTION:
During engine assembly removal, hold the engine
securely and
be
careful not
to
damegtl the frame
and engine.
ENGINE INSTALLATION
6-4
Install the engine onto the frame in the reverse
order of removal.
NOTE :
• Note the installation of the hanger bolts. All bolts
are Installed from left side.
• The jack height must be continually adjusted to
relieve stress from the hanger boilS.
Tighten the hanger nuts to the specified torque.
TORQUE: 31 N·m (3.2 kgf·m, 23Ibf.tt)
Install the removed parts from engine removal
procedure (page 6-2 to 6-3) in the reverse order of
removal.
NOTE:
• Replace the intake manifold D-ring w ith a new
one.
• Note the installation of the brake pedal return
spring.
TORQUE:
Fixing plate bolt: 12 N·m (1.2 kgf·m, 9Ibf·ft)
Install the following:
- left crankcase cover (page 10-8)
- exhaust system (page 2-5)
Adjust the drive chain slack (page 3-12).
Fill the recommended engine oil (page 3-9).
•
•
•
•
•
•
•
•
•