Wheel Bearing Installation - Honda 2000 XR50R Service Manual

REAR WHEEL/BRAKE/SUSPENSION
13-6
Wheel bearing Installation
CAUTION:
Never install the old bearings,
once
the
Narings
has
b99n removed, the bearing must be replaced
with new ones.
Pack each wheel bearing cavity with grease.
Drive in a new right bearing squarely with the
sealed side facing up using the special tools as
shown.
TOOLS:
Driver
Attachment, 32 X 35 mm
Pilot, 12 mm
07749-0010000
07746 - 00 10100
077 46- 0040200
Install the distance collar and drive in a new left
bearing using the same tools.
Wheel center 8.djustment
Place the rim on the work bench.
Place the hub with the left side down and begin
lacing with new spokes.
Adjust the hub position so that the distance from
the hub right end surface to the side of rim is 25
±
1 mm (1.0
±
0.04 in) as shown.
TOOL:
Spoke wrench, 4.1 X 4.5 mm 07701 - 0020100
(Equivalent com-
mercially available
in U.S .A.)
TORQUE: 2 N·m 10.2 kgf.m, 1.4Ibf·ft)
Check the rim runout (page 13-4).
Apply grease to a new dust seal lips and install it
into the left wheel hub.
Install the driven sprocket, bolts and nuts and
tighten them.
TORQUE: 32 N·m (3.3 kgf.m , 24Ibf·ft)
•
•
~25 ± 'mm
/I \\
l-
1/ \ \
~
i l
~
-
•