Handlebar Installation - Honda 2000 XR50R Service Manual

FRONT WHEEL/BRAKE/SUSPENSION/STEERING
12-4
Remove the two nuts and handlebar.
INSTALLATION
Install the handlebar into the fork top bridge and
tighten the mounting nuts.
TORQUE: 20 N·m (2.0 kgf.m, 14Ibf·ft)
Clean the inside surface of the left handlebar grip
and the outside surface oftha left handlebar. GRIP
Apply Honda Bond A or equivalent to the inside
surface of the left handlebar grip and to the out side
surface of the left handlebar. Wait 3 - 5 minutes
and install the grip.
Rotate the grip for even application of the adhesive.
NOTE:
Allowthe adhesive to dry for an hour before using.
Apply grease ,t o the throttle grip pipe flange and
install the throttle grip onto the right handlebar.
Connect the throttle cable to the throttle grip pipe
flange.
Install the engine stop switch/throttle housing onto
the handlebar, aligning the mating surface with the
punch mark on the handlebar.
Tighten the forward screw first, then the rear screw.
TORQUE: 3 N·m 10.3 kgf.m , 2.2 Ibf.ft)
•