Table of Contents
Advertisement
installation
|
24
HEARTH TRIM INSTALLATION
Customize Hearth Trim:
a) The Hearth Trim can be adjusted to custom fit an installation by
pulling apart the top piece from the bottom piece.
b) Cut the top of the bottom piece of the hearth trim to the appropriate
height using a metal cutting blade.
NOTE: The tab bends at the back of the top piece of the hearth trim
should be used as the measuring point to the hearth to measure the
height required.
c) Reattach the top piece of the hearth trim to the cut bottom piece by
fitting in place.
Hearth Trim Installation:
1) Align the screw holes on the hearth trim brackets with the screw
holes on the lower legs of the faceplate backing. Secure in place
using 1 screw through hearth trim bracket and lower leg of facepalte
backing on each side as shown in Diagram 1.
Diagram 1
24 |
Regency
L234-10 Direct Vent Gas Insert
®
919-477
OPTIONAL HEARTH TRIM
1
2) Attach the supplied brackets to the top of the hearth trim with 2 screws.
Note: orientation of brackets is different when using spacer.
Diagram 2
3) Install the hearth trim through the lower legs of the faceplate backer
and spacer together.
Install hearth trim with faceplate
backer and spacer together -
same location as in Step 1
4) Install outer faceplate.
Completed Hearth Trim Installation:
Bracket in correct position
for use without spacer
Bracket in correct position
for use with spacer
Diagram 3
Diagram 4
11.03.14
Hide quick links:
Advertisement
Table of Contents
