Log Set Installation - Regency L234-NG10 Owners & Installation Manual

LOG SET INSTALLATION

Read the instructions below carefully and refer to the images.
Dangerous operating conditions may occur if the logs are not
positioned in their correct locations. If the logs are broken
do not use the unit until they are replaced. Broken logs can
interfere with the pilot operation.
Log kit (Part # 536-930) contains the following pieces:
a) 2-711 Rear Log
b) 2-712 Center Log
c) 2-713 Left Log
d) 2-714 Front Log
e) 2-715 Top Left Log
f) 2-716 Top Right Log
g) Embers
(supplied with packaged manual)
h) 946-669 Platinum Embers
2-711
2-713
1) Carefully remove the logs from the box and unwrap them. The logs
are fragile, handle with care - do not force into position.
2) Fit log 2-711 into the pins on the rear log tray.
2-711
918-674a
LOG SET INSTALLATION
(supplied with packaged manual)
2-716
2-715
2-712
2-714
3) Place log 2-714 on the base of the fi rebox in front of the burner.
4) Fit log 2-712 into the pins on the middle of the burner.
2-712
Regency
1
installation
2-711
2-714
L234-10 Direct Vent Gas Insert
®
L234
|
19
| 19
01/03/08