Safety Decal - Regency L234-NG10 Owners & Installation Manual

safety decal

|
4
This is a copy of the labels that accompany each
L234 Gas Insert. We have printed a copy of the
contents here for your review. The safety label
is located on a plate inside the base of the unit
visible when the bottom louver is opened. Ensure
that the safety label is attached to the unit.
NOTE: Regency units are constantly being
improved. Check the label on the unit and
if there is a difference, the label on the unit
is the correct one.
For the State of Massachusetts, installation
and repair must be done by a plumber or
gasfitter licensed in the Commonwealth of
Massachusetts.
For the State of Massachusetts, flexible
connectors shall not exceed 36 inches in
length.
For the State of Massachusetts, the appli-
ances individual manual shut-off must be a
t-handle type valve.
The State of Massachusetts requires the
installation of a carbon monoxide alarm in
accordance with NFPA 720 and a CO alarm
with battery back up in the same room where
the gas appliance is installed.
4 |
Regency L234-10 Direct Vent Gas Insert
®
Listed: VENTED GAS FIREPLACE HEATER /
FOYER AU GAZ À ÉVACUATION
Certified for/Certifi e pour: CANADA and U.S.A. é
Certified to: CAN/CGA-2.17-M91(R2009)
Tested to: ANSI Z21.88-2014 & CSA 2.33-2014
4001172
NATURAL GAS FIREPLACE INSERT: MODEL
Factory Equipped For Altitude 0-4500ft. (0-1370m)
Min. Supply Pressure
Low Setting Man. Pressure
Max. Manifold Pressure
Orifice Size
Minimum Input
Maximum Input
PROPANE GAS FIREPLACE INSERT: MODEL
Factory Equipped For Altitude 0-4500ft. (0-1370m)
Min. Supply Pressure
Low Setting Man. Pressure
Max. Manifold Pressure
Orifice Size
Minimum Input
Maximum Input
Mantel Clearances
Alcove Width E 66" (1524mm)
Alcove Depth F 36" (914mm)
Non-Combustible Hearth Extension
Hearth Height G 1-1/2" (38mm)
Hearth Width H 28" (711mm)
Hearth Depth I 12" (305mm)
* Alcove side wall must have a
min. of 8" clearance on one side.
FPI Fireplace Products International Ltd.,
Delta BC, CANADA
This appliance must be installed in accordance with local codes, if any; if none, follow the National Fuel Gas Code, ANSI Z223.1, or Natural Gas
and Propane Installation Code, CSA B149.1.
This appliance must be installed in accordance with the Standard CAN/CSA Z240 MH, Mobile Housing, in Canada, or with the Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part 3280, in the United States, or when such a standard is not applicable, ANSI/NCSBCS
A225.1/NFPA 501A, Manufactured Home Installations Standard
This appliance is only for use with the type of gas indicated on the rating plate and may be installed in an aftermarket, permanently located,
manufactured (mobile) home where not prohibited by local codes. See owner's manual for details.
This appliance is not convertible for use with other gases unless a certified kit is used.
WARNING: This fireplace has been converted for use with a gas fireplace insert only and cannot be used for burning wood or solid fuels unless all
original parts have been replaced, and the fireplace re-approved by the authority having jurisdiction.
Installer l'appareil selon les codes ou règlements locaux, ou, en l'absence de tels règlements, selon les codes d'installation ANSI Z223.1, National Fuel
Gas Code ou CSA-B149.1 en vigueur.
Installer l'appareil selon la norme CAN/CSA-Z240, Série MM, Maison mobiles ou CAN/CSA-Z240 VC, Véhicules de camping, ou la norme 24 CFR Part
3280, Manufactured Home Construction and Safety Standard. Si ces normes ne sont pas pertinentes, utilisez la norme ANSI/NCSBCS A225.1/NFPA
501A, Manufactured Home Installations Standard
Cet appareil doit être utilize uniquement avec le type de gaz indiqué sur la plaque signalétique. Cet appareil peut être installé dans une maison
préfabriquée ou mobile (É.-U. seulement) installée à demeure si les règlements locaux le permettent. Voir la notice de l'utilisateur pour plus de
renseignements. Cet appareil ne peut pas être utilisé avec d'autres gaz sauf si une trousse de conversion certifiée est fournie.
Cet appareil n'est pas convertible pour une utilisation avec d'autres gaz, sauf si un kit certifié est utilisé.
AVERTISSEMENT : Ce foyer a été converti pour utilisation avec un foyer au gaz encastrable et ne peut être utiliser pour brûler du bois ou d'autres
combustibles solides à moins que toutes les pièces d'origine aient été remplacées et que le foyer ait été approuvé de nouveau par l'autorité compétente.
This vented gas fireplace heater is not for use with air filters.
For use with glass doors certified with the appliance only
For Use Only with Barrier (Part #537-000) Follow installation instructions.
Utiliser uniquement avec l'écran ( n ° 537-000) Suivre les instructions d'installation.
VENTED GAS FIREPLACE HEATER -
GAZ À ÉVACUATION - NE PAS UTILISER AVEC DUCOMBUSTIBLE SOLIDE.
Part #: 919-443
Colour: Black on Grey except selected text is in red as per this print.
Material: 2 ml silver matt polyester (DPM SMS)
Size: 6.48" W x 8.58" H
File at 100%
Oct.09/14: Created Decal
Added French
*Printer: Continue number sequence from 918-668 - do not restart at 0
Duplicate Serial number
É QUIP A L'UISINE POUR GAZ NATURAL
L234-NG10
5" WC (1.25 kpa) Pression d'allimentation minimum
Pression
1.1" WC (0.27 kpa)
3.8" WC (0.95 kpa) Pression
Dimensions de l'orifice
42 DMS
12,500 Btu/h (6.89 kW) D bit Calorifique minimum é
23,500 Btu/h (3.66 kW) D bit Calorifique maximum é
L234-LP10
É QUIP A L'UISINE POUR GAZ PROPANE
Pression d'allimentation minimum
12" WC (2.99 kpa)
Pression
2.9" WC (0.72 kpa)
Pression
11" WC (2.74 kpa)
Dimensions de l'orifice
54 DMS
D bit Calorifique minimum é
11,000 Btu/h (6.30 kW)
21,500 Btu/h (3.22 kW)
D bit Calorifique maximum é
ELECTRICAL SUPPLY/ALIMENTATION ELECTRIQUE:
B
115V60HZ less than/Moins de 2 AMP.
D
F
Minimum Clearances to Combustibles from Insert
A
I
Side Walls
C
H Ceiling
G
Min. Mantel Height
E
Max. Mantel Depth
Alcove Width
MADE IN CANADA /FABRIQUE AU CANADA
Ne pas utiliser de filtre à air avec ce foyer au gaz à évacuation.
Pour utilisation uniquement avec les portes en verre certifiées avec l'appareil
NOT FOR USE WITH SOLID FUELS. /
332
DO NOT REMOVE THIS LABEL /
NE PAS ENLEVER CETTE ETIQUETTE
332
Serial No. / No de serie
É
à la tubulure d' chappement basse é
à la tubulure d' chappement lev e é é é
É
à la tubulure d' chappement basse é
à la tubulure d' chappement lev e é é é
Fan Part No. 910-331/P
*A 8" (203mm)
B 56" (1422mm)
C 21" (533mm)
D 12" (914mm)
E 76" (1930mm)
FOYER AU
919-443