Conversion From Ng To Lp - Regency L234-NG10 Owners & Installation Manual

installation
|
16

CONVERSION FROM NG TO LP

THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER, IF IN DOUBT DO NOT DO THIS CONVERSION!!
LP Conversion Kit Contains:
Qty. Part # Description
1 910-037 LP Pilot Orifi ce
1 904-163 Orifi ce #54
1 904-529 5/32" Allen Key
1 910-582 Stepper Motor
1 918-590 LP Conversion Decal
1 908-528 Red Propane Label
1 919-465 Instruction Sheet
1. Shut off gas and electrical supply to the unit.
2. Remove the faceplate.
3. Remove the safety screen and glass door
- see manual for detailed instructions.
4. Remove the logs if installed.
5. Remove the brick panels if installed.
6. Remove the burner by undoing the 3 screws.
Burner Removed
16 |
Regency L234-10 Direct Vent Gas Insert
®
919-465
CONVERSION KIT #537-969 FROM NG TO LP
LP Conversion Instructions
7. Remove the burner tray by undoing the 4
screws.
8. Remove burner orifi ce with a 1/2" wrench
and discard.
9. Install the new LP burner orifi ce stamped
#54 and tighten.
10. Pull off the pilot cap to expose the pilot
orifi ce.
Burner Tray Removed
1
11. Unscrew the pilot orifi ce with the supplied
allen key and replace it with the LP pilot orifi ce
in the kit and re-install the pilot cap.
12. Remove NG stepper motor by removing 3
screws in locations shown below–replace
with LP stepper motor, secure in place
with 3 screws.
Remove NG Stepper motor and
replace with LP Stepper motor
13. Check for gas leaks with a proper soapy
solution or leak detector.
14. Check inlet and outlet pressures. Refer
to "Gas Pipe Pressure Testing" section of
the manual.
15. Attach the label "This unit has been con-
verted to LP" near or on top of the serial #
decal.
15. Replace yellow "NG" label with red "LP"
label.
16. Reverse Steps 8 - 1.
NOTE: before re-installng burner, check the
LP aeration settings.
17. Check operation of fl ame control.
18. Check for proper fl ame appearance and
glow on logs.
L234
11.25.14