Wiring Diagrams - Regency L234-NG10 Owners & Installation Manual

WIRING DIAGRAMS

This heater does not require a 120V A.C. supply for operation. However,
a 120V A.C. power supply is needed for the fan/blower operation.
Caution: Ensure that the wires do not touch any hot
surfaces and are away from sharp edges.
CAUTION: Label all wires prior to disconnection
when servicing controls. Wiring errors can cause
improper and dangerous operation.
washer
Power
ground
Star
washer
Lockwasher
Nut
Star
Nut
#8 Ground Lug
Fan
cord ground
REMOTE
wire
WARNING: Electrical Grounding Instructions
This appliance is equipped with a three pronged
(grounding) plug for your protection against shock
hazard and should be plugged directly into a
properly grounded three-prong receptacle. Do not
cut or remove the grounding prong from this plug.
TH
To
Electrode
DC
Spark Box
(+) (-)
TP
Red
Black
TPTH
9
Thermostat
(Optional)
(Millivolt)
Regency
installation
Neutral
Live
120V AC
60 Hz
To
Electrode
White Green
L234-10 Direct Vent Gas Insert
®
|
25
Green
Ground
Ground
ON
Red
Rot
Minimum Convection
C
Air Temp. Switch
| 25