Check Message" Printouts - Muratec PLAIN-PAPER DIGITAL FAX/COPIER/PRINTER/SCANNER MFX-1330 User Manual

Message on the LCD
Too Many Steps
Try Again When
Printing Is Over
Unable to Reduce
Unable to Sort
Start/Stop
Use FBS Glass
* The document glass is available only for MFX-1330 model.

"Check Message" printouts

When there is a problem with a fax call and your machine detects an error, it produces
an error printout headed by the words "Check Message". This printout lists the follow-
ing information about the fax transaction:
• The resulting error code (See "Error code" next page.)
• A communications error message (See "What error messages can mean" below.)
• The TTI (or phone number) of the fax machine with which your machine had
attempted to communicate.
What error messages can mean
The error messages on Check Message printouts can mean a variety of things. Here is a
brief summary:
Error message
Check condition of remote fax.
Repeat transmission.
Line is busy.
Check received documents.
Memory full.
Dialing number is not set.
Stopped.
You tried to enter too many steps for a macro. You can enter up to 60 steps into a macro
key.
You tried to use the real time transmission while the machine is printing. To use the
real time transmission, please try again after the printing is over.
In the reduction copy using the ADF, if the calculated ratio is smaller than minimum
reduction ratio (25%), this message will appear and you cannot make the reduction copy.
Use the document glass*, though parts of the image might not be copied.
In PC printing, the data is too large to sorting.
Press the machine makes a print without collation. Press
START
printing job will be canceled.
You tried to enlargement copy using the ADF.
Your machine cannot enlargement copy from the ADF. Please set your document on the
document glass* to make the enlargement copy.
M
Description / Solution
Possible meanings
• Remote machine malfunctioned
• No "Handshake" signals from remote fax
• Wrong phone number reached
• Poor phone line conditions
• No "Handshake" signals from remote fax
• Document misfeed or miscount
• Unable to reach remote machine after attempt-
ing specified number of redial tries
• Remote machine's line was busy
• Remote machine's line didn't answer
• Remote confirmation signal not received from
remote fax
• Poor line conditions caused a poor image
• Remote fax's memory is full
• Stored phone number failed to dial properly
• Someone pressed
STOP
middle of the "Handshake"
& P
AINTENANCE ROBLEM SOLVING
the current PC
STOP
at the remote fax in the
12.17
1
2
3
4
5
6
7
8
9
10
11
12
A