Setting And Enabling The Dome Password - American Dynamics SpeedDome Ultra VII Operator's Manual

Setting and Enabling the Dome Password

To prevent unauthorized use of the configuration utility, you may choose to enable password
protection. There are two parts to using passwords with your dome: setting a password and
enabling password use. The dome password can be from 1 to 8 characters long. The
characters available depend on the current language setting.
Setting or Changing the Dome Password
1. Select Language/Password from the Dome Configuration Menu.
2. Select Set Password.
The Set Password screen appears.
3. Move the blinking highlight around the available characters. When the correct character
is highlighted, press Focus.
If you make a mistake, press Zoom In to move the cursor one space right or Zoom Out
to move the cursor one space left.
4. Repeat step 3 until the password is complete. When finished, select Continue.
5. You must successfully enter the password twice. Use the procedure in step 3 to enter the
password again. When finished, select Continue.
6. The Language/Password screen appears. Select Exit. The Dome Configuration Menu
appears. Continue with What To Do Next on page 6-6.
Configuring Language and Password Settings
SET PASSWORD
PASSWORD: ********
A B C D E F G H I J K L M N O P Q R S T
U V W X Y Z a b c d e f g h i j k l m n
o p q r s t u v w x y z
7 8 9 / -
CONTINUE
Note: If the passwords do not match, you must start over. Return to step 3
and repeat the procedure.
0 1 2 3 4 5 6
CANCEL
Blank Space
character
6-5