American Dynamics SpeedDome Ultra VII Operator's Manual page 65

5. Press Zoom to change the number. When the item whose name you want to change
appears press Focus Far.
Note:
points to the starting position of the associated selection each time the number is
advanced.
6. The Name Programming screen appears.
Figure 5-6: Example Name Programming Screen
7. Move the blinking highlight around the available characters. When the correct character
is highlighted, press Focus to select it.
If you make a mistake, Zoom In moves the cursor one space right, and Zoom Out
moves the cursor one space left in the name.
8. Repeat step 7 until the name is complete.
9. Do one of the following:
•
To save the name changes, select Exit.
• To discard the name changes, select Undo Changes and Quit.
10. Do one of the following:
•
If you were changing the camera name, continue with step 12.
• If you were changing the name of an area, preset, pattern or alarm, the Select Name
to Program screen appears. Continue with step 11.
11. Do one of the following:
• To make additional changes to the same type of name selected in step 3, repeat steps 4
through 10.
• To return to the Name Configuration Menu, select Exit, and continue with step 12.
12. Do one of the following:
•
To make additional name changes, repeat steps 3 through 11.
• To return to On-Screen Text Display, select Exit. Continue with step 13.
13. Select Exit. The Dome Configuration Menu appears. Continue with What To Do Next
on page 5-14.
Configuring Text Displayed On-Screen
If Presets, Patterns, or Areas have been programmed, the dome automatically
NAME PROGRAMMING
CAMERA /PRESET/PATTERN/AREA/ALARM
NAME: CAMERA.............
A B C D E F G H I J K L M N O P Q R S T
U V W X Y Z a b c d e f g h i j k l m n
o p q r s t u v w x y z
7 8 9 / -
UNDO CHANGES AND QUIT
0 1 2 3 4 5 6
EXIT
Blank Space
character
5-11