American Dynamics SpeedDome Ultra VII Operator's Manual page 45

Note: When areas are programmed, each area is assigned a default name. Instructions for
assigning new names appear in Chapter 5.
To program areas, select Area Boundaries from the Alarms/Areas/Home/Presets/PZ
screen. The following screen appears:
If no boundary is set, pressing Focus quits without making any changes.
The dome supports from 2 to 16 areas.
I M P O R T A N T
If areas were previously programmed, you cannot restore the previously programmed
boundaries by selecting Quit Without Saving from the Dome Configuration Menu once
you begin making changes to the boundaries.
Configuring Alarms, Areas, Home, Privacy Settings, and Presets
AREA BOUNDARIES
PAN to start of BOUND 1-16
PAN RIGHT ONLY
ZOOM to mark BOUNDARY
FOCUS saves and exits
4-11