American Dynamics SpeedDome Ultra VII Operator's Manual page 46

Setting Area Boundaries
1. Select Alarms/Areas/Home/Presets/PZ from the Dome Configuration Menu.
2. Move the highlight bar to Area Boundaries, then select.
The Area Boundaries screen appears.
3. Adjust the camera to the starting point of the first area, and press Zoom to mark the
boundary.
4. Adjust the dome to the right until the ending point of the area is seen. If you attempt to
move left, an error message appears. See the note on page 4-12 for information.
5. Mark the end-point of the area.
The area number automatically advances.
6. Repeat steps 4 and 5 for each area you want to establish.
7. When the last area boundary is set, save the changes. A message appears confirming that
the areas have been successfully saved. Press Focus to continue.
8. When the Alarms/Areas/Home/Presets/PZ screen appears, select Exit. The Dome
Configuration Menu appears. Continue with What To Do Next on page 4-20.
4-12
Note:
You will receive an error message under the following conditions:
• If you attempt to program an area boundary that passes the starting
point of the first area
• If you move the camera left after establishing the first boundary
Return to step 2 and start again.
SpeedDome Ultra VII Operator's Manual