Folds, Bends And Curls Of Cut-Sheet Paper - Oki ML1120 Technical Reference Manual

> An example of paper with perforations is illustrated below.
> Printing data in the hatched area (illustrated below)
around perforations is not allowed.
> Perforations should not have any rough edges.
> Paper should be smooth on the cut edge.
> Perforations should be evenly applied.
Cuts uncrossed
Uncut
4 portions
F ,
OLDS BENDS AND CURLS OF CUT
Cut-sheet paper is likely to have folds, bends or curls through
handling, carrying or stacking, or depending on storage
conditions. To avoid such effects interfering with paper feed,
suggestions are offered below.
Do not use cut-sheet paper which is out-of-specification as this
can have a detrimental effect on its feed. If any problems occur
with using such paper, equipment or performance is not assured.
Folds
> Cut sheets folded all the way from side to side are
unusable.
Technical Reference Guide – Appendix D – Media specifications > 244
Vertical perforation
5.08
5.08
The hatched area must not be printed on.
-
SHEET PAPER
Horizontal perforation
5.05
5.05
[All dimensions in mm]