Oki ML1120 Technical Reference Manual page 231

of about 3 mm between parts. Stapling with metal staples is
strictly prohibited.
Spot gluing
> Forms are to be spot glued at both sides (single-side spot
gluing is not allowed).
> Each glue application spot must be glued evenly, and be of
3 to 5 mm in size. The glue spot is to be accurately
pressed to prevent its floating and there is to be no
significant creasing.
> For positioning of glue spots, see the illustration below.
> Spot gluing is to be applied in a staggered format.
Gluing the lines
> The glue line area should be even, with a width of 1 –
2 mm.
> Always press the glue line area to prevent any lifting.
Further, do not use any paper which has significant
wrinkling.
> Ensure that the glue does not extend outside the margins
of the paper.
Technical Reference Guide – Appendix D – Media specifications > 231
Glue spot