Initialising Menu Settings - Oki ML1120 Technical Reference Manual

MENU ITEM
Serial I/F Parity
menu
Serial Data 7/
8 Bits
Protocol
Diagnostic
Test
Baud Rate
DTR Signal
Busy Time
I
NITIALISING MENU SETTINGS
To restore the menu settings to their initial values, carry out the
steps below.
NOTE
The values adjusted by the Adjustment menus are not
initialised by the following procedure.
1. Set the Power Switch to OFF.
Technical Reference Guide – Operator interface > 74
FUNCTION
Set parity.
Set serial data
length.
Set protocols.
Set/Cancel loop
testing of the
serial interface.
Set the
transmission
speed of the
serial interface.
Set whether to
switch the DTR
signal of the
serial interface
by Select/
Deselect or hold
it after power-
on.
Set the
minimum time it
takes to switch
from a busy
state to a ready
state.
SETTING
None
Odd
Even
Ignore
8 bit
7 bit
DTR
X-ON/X-OFF
DTR & X-ON/X-OFF
No
Yes
9,600 bps
4,800 bps
2,400 bps
1,200 bps
600 bps
300 bps
19,200 bps
Ready on Power UP
Ready on Select
0.2 sec
1.0 sec