Oki ML1120 Technical Reference Manual page 54

MENU ITEM
Rear feed Line Spacing
menu
Form Tear-
Off
Skip Over
Perforation
Page Length
Cut position
adjust
Technical Reference Guide – Operator interface > 54
FUNCTION
Select line feed pitch.
Select manual or auto
as the method to
advance a continuous
form to the form tear-
off position.
Select whether to skip
over perforation or
not. (When a skip
over perforation setup
command is received,
the received
command is given
priority.)
Select the length of a
continuous form.
Cut position adjust
Select an adjustment
value for the position
to cut the end of a
continuous form. (In
1/144 in increments)
SETTING
6 LPI
8 LPI
Off
500 ms
1 sec
2 sec
Yes (25.4 mm/ 1 in)
No
279.4 mm(11 in)
296.3 mm(11 2/3 in)
304.8 mm (12 in)
355.6 mm(14 in)
431.8 mm(17 in)
76.2 mm(3 in)
82.6 mm(3.25 in)
84.7 mm(10/3 in)
88.9 mm(3.5 in)
93.1 mm(11/3 in)
101.6 mm(4 in)
127.0 mm(5 in)
139.7 mm(5.5 in)
152.4 mm(6 in)
177.8 mm(7 in)
203.2 mm(8 in)
215.9 mm(8.5 in)
-20 – -1
0
+20 – +1