Feed Hole (Sprocket Hole) Positions And Sizes - Oki ML1120 Technical Reference Manual

Vertical dimension
The following is standard for the vertical dimension T.
TYPE (NAME)
T11
For usable areas, see
page 228.
Horizontal dimension
The following is a standard for the horizontal dimension Y.
TYPE (NAME)
Y10
For usable areas, see
page 228.
Folding dimension
The following is a standard folding dimension. Paper is to be fan-
folded along perforations.
TYPE (NAME)
F11
F (
EED HOLE SPROCKET HOLE
Sprocket hole positions and sizes are shown below. For this
section, a centre line is defined as a centre-to-centre line
between any two sprocket holes approximately 254 mm apart in
the direction of paper feed.
ITEM
Distance between
centre line and paper
edge on same side
Technical Reference Guide – Appendix D – Media specifications > 224
DIMENSION (MM)
279.4
"Paper size and printing areas" on
DIMENSION (MM)
254.0
"Paper size and printing areas" on
DIMENSION
(MM)
279.4
)
POSITIONS AND SIZES
DIMENSION (MM)
A
TOLERANCE (MM)
±0.5
TOLERANCE (MM)
+1.5, -0.5
CORRESPONDING VERTICAL
DIMENSION TYPE
T11
6.35 ±0.7
REMARKS
6.35 mm is
standard.