Yamaha XT1200Z 2010 Service Manual page 517

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
Fault code No.
Item
3 Connection of ABS ECU
coupler.
Check the locking condition
of the coupler.
Disconnect the coupler and
check the pins (bent or bro-
ken terminals and locking
condition of the pins).
4 Connection of wire harness
ECU coupler.
Check the locking condition
of the coupler.
Disconnect the coupler and
check the pins (bent or bro-
ken terminals and locking
condition of the pins).
5 Wire harness continuity.
email: info@motomatrix.co.uk
69
Front wheel sensor: no normal signals are received from the
rear wheel sensor.
Improperly connected →
Connect the coupler secure-
ly or repair/replace the wire
harness or sub wire harness.
Improperly connected →
Connect the coupler secure-
ly or repair/replace the wire
harness or sub wire harness.
Open or short circuit → Re-
place the wire harness.
Between front wheel sensor
coupler and ABS ECU cou-
pler.
black–black
white–white
Between ABS ECU coupler
and ECU coupler.
blue/black–blue/black
blue–blue
8-68
FUEL INJECTION SYSTEM
Execute the diagnostic
mode. (Code No. d:16)
Rotate the front wheel by
hand and check that the indi-
cated value increases.
Value increases → Start the
engine, and input the vehicle
speed signals by operating
the vehicle at 20 to 30 km/h.
The fault code can also be
deleted by activating the di-
agnostic mode and selecting
diagnostic code number "d:
63"
Value does not increase →
Go to item 4.
Execute the diagnostic
mode. (Code No. d:16)
Rotate the front wheel by
hand and check that the indi-
cated value increases.
Value increases → Start the
engine, and input the vehicle
speed signals by operating
the vehicle at 20 to 30 km/h.
The fault code can also be
deleted by activating the di-
agnostic mode and selecting
diagnostic code number "d:
63"
Value does not increase →
Go to item 5.
Execute the diagnostic
mode. (Code No. d:16)
Rotate the front wheel by
hand and check that the indi-
cated value increases.
Value increases → Start the
engine, and input the vehicle
speed signals by operating
the vehicle at 20 to 30 km/h.
The fault code can also be
deleted by activating the di-
agnostic mode and selecting
diagnostic code number "d:
63"
Value does not increase →
Go to item 6.