Yamaha XT1200Z 2010 Service Manual page 247

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
9. After releasing the start switch, operate the
brake lever and the brake pedal simulta-
neously.
10.A reaction-force pulsating action is generated
in the brake lever "1" 0.5 second after the
brake lever and the brake pedal are operated
simultaneously and continues for approxi-
mately 2.5 seconds.
TIP
• The reaction-force pulsating action consists of
quick pulses.
• Be sure to continue operating the brake lever
and brake pedal even after the pulsating action
has stopped.
1
11.After the pulsating action has stopped in the
brake lever, it is generated in the brake pedal
"1" 0.5 second later and continues for approx-
imately 2.5 seconds.
TIP
• The reaction-force pulsating action consists of
quick pulses.
• Be sure to continue operating the brake lever
and brake pedal even after the pulsating action
has stopped.
email: info@motomatrix.co.uk
ABS (Anti-Lock Brake System)
1
12.After the pulsating action has stopped in the
brake pedal, it is generated in the brake lever
0.5 second later and continues for approxi-
mately 2.5 seconds.
TIP
The reaction-force pulsating action consists of
quick pulses.
ECA23P1032
NOTICE
• Check that the pulsating action is felt in the
brake lever, brake pedal, and again in the
brake lever, in this order.
• If the pulsating action is felt in the brake
pedal before it is felt in the brake lever,
check that the brake hoses and brake pipes
are connected correctly to the hydraulic
unit assembly.
• If the pulsating action is hardly felt in either
the brake lever or brake pedal, check that
the brake hoses and brake pipes are con-
nected correctly to the hydraulic unit as-
sembly.
13.Release the brake lever and brake pedal,
and then set the main switch to "OFF".
ECA23P1031
NOTICE
If the main switch is set back to "ON" while
the brake lever and brake pedal are operated,
the hydraulic unit operation test cannot be
restarted.
14.Remove the test coupler adapter from the
ABS test coupler, and then install the protec-
tive cap.
15.Set the main switch to "ON".
16.Set the engine stop switch to "
17.Check for brake fluid leakage around the hy-
draulic unit.
Brake fluid leakage → Replace the hydraulic
unit assembly, brake pipes, and related parts
as a set.
4-74
".