Yamaha XT1200Z 2010 Service Manual page 512

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
Fault code No.
Item
Meter display
d:15
Procedure
Probable cause of mal-
Item
function and check
1 Connection of accelerator
position sensor coupler.
Check the locking condition
of the coupler.
Disconnect the coupler and
check the pins (bent or bro-
ken terminals and locking
condition of the pins).
2 Connection of wire harness
ECU coupler.
Check the locking condition
of the coupler.
Disconnect the coupler and
check the pins (bent or bro-
ken terminals and locking
condition of the pins).
3 Wire harness continuity.
4 Installed condition of accel-
erator position sensor.
Check for looseness or
pinching.
email: info@motomatrix.co.uk
59
Accelerator position sensor: open or short circuit detected.
Accelerator position sensor signal 2
• 9–25 (fully closed position)
• 97–113 (fully open position)
• Check with throttle grip in fully closed position.
• Check with throttle grip in fully open position.
Maintenance job
Improperly connected →
Connect the coupler secure-
ly or repair/replace the wire
harness.
Improperly connected →
Connect the coupler secure-
ly or repair/replace the wire
harness.
Open or short circuit → Re-
place the wire harness.
Between accelerator position
sensor coupler and ECU
coupler.
black/blue–black/blue
white–white
black–black
blue–blue
Improperly installed sensor
→ Reinstall or replace the
sensor.
Refer to "CHECKING THE
ACCELERATOR POSITION
SENSOR" on page 8-153.
8-63
FUEL INJECTION SYSTEM
Confirmation of service
completion
Set the main switch to "ON".
Fault code number is not dis-
played → Service is finished.
Fault code number is dis-
played → Go to item 2.
Set the main switch to "ON".
Fault code number is not dis-
played → Service is finished.
Fault code number is dis-
played → Go to item 3.
Set the main switch to "ON".
Fault code number is not dis-
played → Service is finished.
Fault code number is dis-
played → Go to item 4.
Set the main switch to "ON".
Fault code number is not dis-
played → Service is finished.
Fault code number is dis-
played → Go to item 5.