Yamaha XT1200Z 2010 Service Manual page 484

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
TIP
• All displays on the meter disappear except the odometer displays.
• "dIAG" appears on the odometer LCD. If "Co" appears on the odometer LCD, press the left set button
to select "dIAG".
4. Simultaneously press the right set button and left set button for 2 seconds or more to set the diag-
nostic mode.
TIP
The diagnostic code number "d:01" appears on the clock LCD.
5. Select the diagnostic code number corresponding to the fault code number by pressing the right set
button and left set button.
TIP
• To decrease the selected diagnostic code number, press the right set button. Press the right set but-
ton for 1 second or more to automatically decrease the diagnostic code numbers.
• To increase the selected diagnostic code number, press the left set button. Press the left set button
for 1 second or more to automatically increase the diagnostic code numbers.
6. Check the operation of the sensor or actuator.
• Sensor operation
The data representing the operating conditions of the sensor appears on the odometer LCD.
• Actuator operation
Set the engine stop switch to "
TIP
If the engine stop switch is set to "
7. Turn the main switch to "OFF" to cancel the diagnostic mode.
TIP
Information about each diagnostic code No. is organized in this manual as follows:
• If a diagnostic code No. has a corresponding fault code No., the information is shown in "TROUBLE-
SHOOTING DETAILS". (Refer to "TROUBLESHOOTING DETAILS" on page 8-36.)
email: info@motomatrix.co.uk
2
" d:01 d:70 "
" to operate the actuator.
", set it to " ", and then set it to "
8-35
FUEL INJECTION SYSTEM
1
" d:70 d:01 "
" again.