Yamaha XT1200Z 2010 Service Manual page 127

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
1. Brake fluid reservoir hose
2. Brake hose (rear brake master cylinder to
hydraulic unit)
3. Rear brake light switch lead
4. Brake hose (hydraulic unit to rear brake caliper)
5. Rear wheel sensor lead
A. Install the brake fluid reservoir hose onto the hose
fitting of the brake fluid reservoir, making sure that
the hose contacts the reservoir.
B. Fasten the brake hose (rear brake master cylinder
to hydraulic unit) with the holder. Position the
–
holder 20 40 mm (0.79
the pipe section of the hose.
C. Make sure that there is no slack in the portion of
the brake hose (rear brake master cylinder to
hydraulic unit) that is routed to the outside of the
frame.
D. Install the brake fluid reservoir hose with its white
paint mark facing toward the swingarm.
E. Install the brake fluid reservoir hose onto the hose
fitting of the rear brake master cylinder, making
sure that the hose contacts the master cylinder.
F. To rear wheel sensor
G. Route the rear wheel sensor lead to the outside of
the brake hose (hydraulic unit to rear brake caliper)
at the location shown in the illustration.
H. Align the center of the holder with the fourth hole
from the rear on the inner side of the brake torque
rod.
I. Position the holder 85
the grommet on the rear wheel sensor lead.
J. Install the holder as shown in the illustration.
K. Fasten the grommets on the rear wheel sensor
lead and the brake hose (hydraulic unit to rear
brake caliper) with the holder.
L. Face the catch of the holder upward.
M. Fasten the rear wheel sensor lead with the holder.
email: info@motomatrix.co.uk
–
1.57 in) from the end of
– –
95 mm (3.35 3.74 in) from
2-66
CABLE ROUTING