Yamaha XT1200Z 2010 Service Manual page 133

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
1. License plate light lead
2. Rear right turn signal light lead
3. Tail/brake light lead
4. Rear left turn signal light lead
5. Frame ground lead
6. Lean angle sensor sub-wire harness
7. ABS test coupler lead
A. Route the license plate light lead and rear right
turn signal light lead between the rib and the
carrier support on the rear fender.
B. Route the license plate light lead and rear right
turn signal light lead to the outside of the rib on the
rear fender.
C. Make sure that the frame ground lead terminal
contacts the stopper on the frame.
D. Route the tail/brake light lead and rear left turn
signal light lead to the outside of the rib on the rear
fender.
E. Route the tail/brake light lead, rear left turn signal
light lead, rear right turn signal light lead, and
frame ground lead to the outside of the rib on the
rear fender.
F. Fasten the lean angle sensor sub-wire harness,
license plate light lead, tail/brake light lead, frame
ground lead, rear left turn signal light lead, and rear
right turn signal light lead with the holder.
G. Route all of the leads between the ribs on the rear
fender.
H. Face the catch of the holder to the left.
I. Route the tail/brake light lead to the front of the
tail/brake light assembly bracket.
J. Route the license plate light lead through the
cutout in the tail/brake light assembly.
email: info@motomatrix.co.uk
2-72
CABLE ROUTING