Yamaha XT1200Z 2010 Service Manual page 107

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
1. Right handlebar switch lead
2. Throttle cable (accelerator cable)
3. Throttle cable (decelerator cable)
4. Clutch hose
5. Left handlebar switch lead
6. Main switch lead
7. Horn lead
8. Front wheel sensor lead
9. Brake hose (hydraulic unit to left front brake
caliper)
10. Immobilizer unit lead
A. Fasten the right handlebar switch lead to the
handlebar with the plastic band at the location
shown in the illustration.
B. Fasten the left handlebar switch lead to the
handlebar with the plastic band at the location
shown in the illustration.
C. Route the main switch lead and left handlebar
switch lead to the front of the immobilizer unit lead
in the order listed from front to rear.
D. Connect the horn connectors, turn the handlebar
completely to the right, and then fasten the horn
lead to the brake hose holder at the white tape with
a plastic locking tie.
E. Route the horn lead over the brake hose (hydraulic
unit to left front brake caliper) and front wheel
sensor lead.
F. Route the immobilizer unit lead over the guide as
shown in the illustration.
G. Face the buckle of the plastic band forward with
the end pointing downward. Do not cut off the
excess end of the plastic band.
H. Fasten the horn lead with a plastic locking tie so
that the lead does not contact the horn. Be sure to
fasten the plastic locking tie around the protective
sleeve of the lead, not the lead itself.
I. Position the plastic locking tie at the location
shown in the illustration.
J. Make sure that there is no slack in the leads in the
area shown in the illustration.
K. Point the end of the plastic band downward. Do not
cut off the excess end of the plastic band.
L. To electrical components tray
M. Face the catch of the holder upward.
N. Face the buckle of the plastic locking tie inward
with the end pointing downward so that the end
does not protrude to the outside of the frame. Do
not cut off the excess end of the plastic locking tie.
O. Fasten the right handlebar switch lead, left
handlebar switch lead, and main switch lead at the
white tape on each lead with a plastic locking tie.
Point the end of the plastic locking tie downward.
Do not cut off the excess end of the plastic locking
tie.
email: info@motomatrix.co.uk
2-46
CABLE ROUTING