Yamaha XT1200Z 2010 Service Manual page 44

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
This display indicates which traction control sys-
tem mode has been selected: "1", "2" or "Off".
For more details on the modes and on how to
select them, refer to "TCS (Traction Control Sys-
tem) function".
Self-diagnosis device
1. Fault code display
This model is equipped with a self-diagnosis de-
vice for various electrical circuits.
If a problem is detected in the immobilizer sys-
tem circuits, the immobilizer system indicator
light flashes and the display indicates a fault
code.
If a problem is detected in any other circuit, the
engine trouble warning light comes on and the
display indicates a fault code.
TIP
If the display indicates immobilizer system circuit
fault code 52, this could be caused by transpon-
der interference. If this fault code appears, try
following the procedure below.
1. Use the code re-registering key to start the
engine.
TIP
Make sure there are no other immobilizer keys
close to the main switch, and do not keep more
than one immobilizer key on the same key ring!
Immobilizer system keys may cause signal inter-
ference, which may prevent the engine from
starting.
2. If the engine starts, turn it off and try starting
the engine with the standard keys.
3. If one or both of the standard keys do not start
the engine, take the vehicle, the code re-reg-
istering key and both standard keys.
If the display indicates any fault codes, note the
code number, and then check the vehicle.
email: info@motomatrix.co.uk
1
1-35
EWA23P1042
NOTICE
If the display indicates a fault code, the vehi-
cle should be checked as soon as possible
in order to avoid engine damage.
LCD and tachometer brightness control
mode
1 2
1. Tachometer panel
2. Tachometer needle
3. LCD
4. Brightness level display
5. Right set button
6. Left set button
This function allows you to adjust the brightness
of the LCD, and the tachometer panel and nee-
dle to suit the outside lighting conditions.
To set the brightness
1. Turn the key to "OFF".
2. Push and hold the left button.
3. Turn the key to "ON", and then release the left
button after five seconds.
4. Push the right button to select the desired
brightness level.
5. Push the left button to confirm the selected
brightness level. The display returns to the
odometer or tripmeter mode.
D-mode (drive mode)
D-mode is an electronically controlled engine
performance system with two mode selections
(touring mode "T" and sports mode "S").
Push the drive mode switch "MODE" to switch
between modes.
FEATURES
3 4
6 5