Yamaha XT1200Z 2010 Service Manual page 131

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
1. Engine ground lead
2. Wire harness
3. ABS ECU lead
4. ABS test coupler
5. ABS test coupler lead
6. Hydraulic unit assembly
7. Coolant reservoir hose
8. Oil level switch lead
9. Sidestand switch lead
10. Fuel hose
11. Rear brake light switch lead
12. Neutral switch lead
13. Fuel pump lead
14. Rear right turn signal light lead
15. Lean angle sensor sub-wire harness/frame ground
lead
16. Tail/brake light lead
17. License plate light lead
18. Rear left turn signal light lead
19. Fuel pump coupler
A. Make sure that the engine ground lead terminal
contacts the stopper on the crankcase.
B. Position the plastic band between the rubber cover
and the split in the wire harness.
C. Insert the projection on the plastic band into the
hole in the rear fender, and then fasten the ABS
ECU lead and wire harness with the band. Route
the wire harness to the outside of the ABS ECU
lead. Point the end of the plastic band to the right
and insert it into the hole in the frame. Do not cut
off the excess end of the plastic band.
D. Slide the rubber cover over the rear turn signal
light connectors, license plate light coupler,
tail/brake light coupler, lean angle sensor sub-wire
harness coupler, and alarm couplers, making sure
that the connectors and couplers are covered
completely.
E. Slide the rubber cover over the sidestand switch
coupler, rear brake light switch coupler, neutral
switch coupler, rear wheel sensor coupler, and oil
level switch coupler, making sure that the couplers
are covered completely.
F. Route the sidestand switch lead and oil level
switch lead over the coolant reservoir hose.
G. Connect the ABS ECU coupler, and then fasten
the wire harness at the white tape with the plastic
band. Point the end of the plastic band downward.
Do not cut off the excess end of the plastic band.
H. Point the end of the plastic band rearward. Do not
cut off the excess end of the plastic band.
I. Fold the ABS test coupler lead, and then fasten the
ABS test coupler lead, lean angle sensor sub-wire
harness, rear right turn signal light lead, rear left
turn signal light lead, tail/brake light lead, and
license plate light lead with the plastic locking tie.
J. Position the plastic locking tie 40
2.36 in) from the edge of the holder.
K. Fit the ABS test coupler in between the ABS unit
cover and the holder.
L. Face the catch of the holder forward or rearward.
M. Route the fuel pump lead above and to the rear of
the fuel hose.
N. Forward
email: info@motomatrix.co.uk
– –
60 mm (1.57
2-70
CABLE ROUTING