Yamaha XT1200Z 2010 Service Manual page 129

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
1. Immobilizer unit lead
2. Cylinder-#1 left ignition coil lead
3. Accelerator position sensor lead
4. Cylinder-#1 right ignition coil lead (white tape)
5. Cylinder-#2 left ignition coil lead
6. Cylinder-#2 right ignition coil lead (white tape)
7. Throttle servo motor lead (yellow tape)
8. Throttle position sensor lead
9. Wire harness
10. Injector #2 lead
11. Coolant temperature sensor lead
12. Injector #1 lead
13. Oil level switch lead
14. Sidestand switch lead
15. Intake air pressure sensor lead
16. Coolant reservoir hose
17. Cylinder head breather hose
18. Throttle position sensor
19. Starter motor lead
20. Negative battery lead
21. Frame
22. Stator coil lead
23. Fuel rail
A. Route the immobilizer unit lead over the cylinder
head breather hose.
B. Route the cylinder-#1 left ignition coil lead under
the cylinder head breather hose.
C. Route the accelerator position sensor lead under
the cylinder head breather hose.
D. Route the cylinder-#1 right ignition coil lead under
the cylinder head breather hose.
E. Insert the projection on the wire harness holder
into the hole in the frame.
F. Position the plastic band to the front of the wire
harness holder, making sure not to install the band
around the holder.
G. To intake air temperature sensor
H. To air filter case
I. To radiator
J. Fasten the leads with the plastic band so that they
do not contact the throttle position sensor. Face the
buckle of the plastic band upward and place the
end of the band between the frame and the wire
harness. Do not cut off the excess end of the
plastic band.
email: info@motomatrix.co.uk
2-68
CABLE ROUTING