Tcm Error Messages - Motorola VC5090 Product Reference Manual

7 - 18 VC5090 Vehicle Computer Product Reference Guide

TCM Error Messages

TCM validates the cells in the partition table when the Execute button is clicked. Cells highlighted in red contain an
error. Partition loading is disabled until all errors are corrected.
Table 7-3 TCM Error Messages
Error
Failed to build images:
flash file system DLL not
loaded!
Failure finding directory
xxx
Failure creating volume
Failure adding system
file to image
INVALID PATH
Nothing Selected To
Build
Illegal ESS ID
Disk Full
Target Disk Full
Hex file is READ ONLY
Error opening the file
xxx with write access
Failure creating binary
file
Hex File To load is
missing or invalid
Could not locate vehicle
computer name in
TCM.ini file
Incorrect disk sizes in
TCM.ini file
INVALID DIRECTORY
One of the disk sizes is
one sector in size
TCM could not load the DLL required to build images for the targeting flash file system.
Reinstall TCM or recover the DLL.
Building process failed because directory xxx was not found.
Building process failed because a certain disk volume could not be created.
Build process failed because TCM failed to add a certain system file to the disk image.
The path for the image file to build is not valid.
In the Config Build window, no item is selected to build.
In the Build ESSID Partition window, no ESS ID was entered or the ESS ID entered was
illegal.
TCM failed to create Hex image file at the selected path. Check available disk space.
Build process failed because TCM failed to add file to the image of a disk volume.
Remove some files or increase the disk size.
The Hex image file to be created exists and is read-only. Delete the existing file or
change its attribute.
TCM could not open file xxx with write access. Check if file is in use.
TCM failed to open/create an intermediate binary file.
In Load Terminal window, the file selected to load has invalid status.
While loading the Script Properties window, TCM could not find the TCM.ini section
corresponding to the vehicle computer type specified by the current opening script.
Either TCM.ini or the script file is invalid.
The total disk size specified in the script does not match the total disk size defined in the
corresponding TCM.ini section. Check if the script is corrupt or the TCM.ini has changed
after the script was created.
In Script Properties window, the selected System File Path is not a valid directory.
In Script Properties window, one of the disks is too small (one sector in size). This may
cause problem while building images, especially when cushion is enabled. Increase the
disk size.
Description/Solution