Removing Power To The Vehicle Computer - Motorola VC5090 Product Reference Manual

Select a location for mounting the filter box. This should be on a hard flat surface and in a location where the
3.
connector end of the cable reaches the vehicle computer.
Secure the filter box of the power cable to the forklift, using #8 screws or bolts.
4.
Connect the green wire to the vehicle's negative power source.
5.
Vehicle
Battery
Wiring Diagram
Figure 2-13
Place a fuse and fuse holder in-line of the red and black wires approximately four inches from the cable end, as
6.
shown in Figure 2-6 on page
Slide shrink tubing over wires.
7.
Strip the wires (0.4 in./10 mm) and insert into the fuse holder. Crimp fuse holder ends to ensure a proper
8.
electrical connection (use Thomas & Betts WT-11-M crimp tool or equivalent).
Heat shrink tubing.
9.
Connect the red wire to the vehicle's positive power source. Connect the black wire to the vehicle's negative
10.
power source.
Ensure the wiring connections created are sufficiently insulated from each other.
11.
Re-connect the vehicle battery.
12.
Insert the power cable connector into the vehicle computer's Power port. Align the keyway on the power
13.
connector with the notch on the vehicle computer's power port.

Removing Power to the Vehicle Computer

NOTE Place the vehicle computer in suspend mode prior to removing power.
If it is required to remove the vehicle computer from a power source (replace a vehicle's battery):
Ensure that all the
1.
icon >
Power Wakeup
Press the Power button on the Quick Access Panel to place the vehicle computer in suspend mode.
2.
Turn the vehicle ignition switch to the off position, if applicable.
3.
Red
20A Fuse
Black
20A Fuse
Green
2-6.
wakeup settings are set to
Forklift Ignition Off
tab to view the wakeup settings.
Installation 2 - 13
Power Cable
25-71919-02R
Filter
Box
. Tap > >
No Settings Control Panel
VC5090
>