Making Prints Using The Stack Bypass - Canon iR 3300 Reference Manual

Making Prints Using the Stack Bypass

Making Prints Using the Stack Bypass

Making Prints Using the Stack Bypass Making Prints Using the Stack Bypass
When making prints on transparencies, or non-standard size paper stock, load the paper stock
in the stack bypass.
IMPORTANT
• • • •
Note the following points when using the stack bypass:
- Copy quantity: 1 to about 50 sheets (stack about 5 mm high)
- Paper size: 100 mm x 139 mm to 297 mm x 432 mm
- Paper weight: 64 g/m
- Curl down paper before use. (Curl amount: less than 10 mm for normal paper; less than 5 mm for
heavy paper) There are some types of paper stock which may meet the above specifications but
cannot be fed in the stack bypass.
• • • •
Do not load different size/type paper at the same time.
• • • •
A4-size tracing paper must be placed vertically in the stack bypass. Placing this paper horizontally
may cause creases on the print, depending on the moisture absorption condition of the paper.
• • • •
A4-size transparencies must be placed vertically in the stack bypass. Placing this paper horizontally
may cause blurred images.
• • • •
When making two-sided prints, select the Two-sided mode. Not selecting the correct mode may,
cause creases on the print, depending on the moisture absorption condition of the paper.
• • • •
To print on the rear side of printed paper, it is recommended you load the paper in one of the paper
drawers.
• • • •
When printing on envelopes, empty the output tray when at most 10 printed envelopes accumulate
in the tray.
• • • •
When you select "Free Size" for copying, you cannot use the Auto Zoom, Entire Image, Finisher,
Hole Punch, 1 2-Sided, 2 2-Sided, Book 2-Sided, Two-page Separation, Cover/Sheet
Insertion, Shift (Centre/Corner), Booklet, Transparency Interleaving, Image Combination, Image
Separation, or Image Repeat modes.
• • • •
When you select "Free Size" for printing documents stored in the mail box, you cannot use the
Finisher, 2-Sided, Document Contiguous/Separate Duplex Printing, Cover/Sheet Insertion, or
Booklet modes.
NOTE
• • • •
When scanning the following originals, you cannot use Automatic Paper Selection. Use Manual
Paper Selection with these types.
- Highly transparent originals such as transparencies
- Originals with an extremely dark background
n Standard Size Standard Size
Standard Size Standard Size
You can select standard inch paper, or A or B series paper.
n Free Size Free Size Free Size Free Size
You can place non-standard size paper (100 mm x 139 mm to 297 mm x 432 mm).
2 2
to 128 g/m
Making Prints Using the Stack Bypass
1 1 1 1
1-47 1-47 1-47 1-47