Setting Staple/Offset To On/Off - Canon iR 3300 Reference Manual

2 2 2 2
Press "Light" or "Dark" to adjust the exposure, and press "OK." Press "Light" or "Dark" to adjust the exposure, and press "OK."
Press "Light" or "Dark" to adjust the exposure, and press "OK." Press "Light" or "Dark" to adjust the exposure, and press "OK."
3 3 3 3
Press "Done." Press "Done." Press "Done." Press "Done."
Repeat this procedure.
The specified mode is set and the display returns to the Basic Features screen.

Setting Staple/Offset to ON/OFF

Setting Staple/Offset to ON/OFF

Setting Staple/Offset to ON/OFF Setting Staple/Offset to ON/OFF
If the service call message containing an error code shown below appears, be sure to turn the
main power switch ON again. After that, if the same message appears when paper is output,
contact your service representative. Follow the procedure shown below if the service
representative asks you to set Staple/Offset to ON/OFF.
• E000500-000
• E000514-000
• E000530-000
• E000531-000
• E000577-000
• E000580-000
• E000585-000
NOTE
• • • •
This setting is available only when Finisher-J1 is attached.
• • • •
The default setting is "On"
1 1 1 1
Call up the desired screen as follows: Call up the desired screen as follows:
Call up the desired screen as follows: Call up the desired screen as follows:
(Additional Functions)
Adjusting the Machine (Adjustment/Cleaning)
3 3 3 3
3-43 3-43 3-43 3-43