Loading Paper In The Stack Bypass - Canon iR1510 Reference Manual

2
n n n n Loading Paper in the Stack Bypass
Use the stack bypass when you want to print on special paper, such as envelopes, transparencies, labels or heavy paper. You can
place up to 100 sheets of 80 g/m
1
Open the stack bypass.
2
Pull out the paper tray.
3
Load the paper stack facing up into the stack bypass.
4
Adjust the slide guides to fit the size of the paper stack.
• If the slide guides are not adjusted correctly for the paper size, the quality of your print
images may be adversely affected.
• When making copies on A4 size paper after having continuously copied on paper
smaller than A4 size paper, the copies may be dirty. To prevent copies from being dirty,
wait about one minute before making copies.
• Insert the paper stack into the machine as far as it will go.
• If the paper is curled, uncurl it before placing it in the stack bypass. Failure to do so will
cause paper creases and a paper jam.
2
• 56 to 128 g/m
• Make sure that the paper stack does not exceed the paper limit guide.
• Some types of paper may not feed properly into the stack bypass. For high-quality
copies, be sure to use the paper and transparencies recommended by Canon. (→ p. 2-1)
• Load transparencies one by one.
• When making copies of a small size document or heavy paper, etc., the copy speed may
be slightly slower than usual.
• To specify the paper size every time you load the paper into the stack bypass, follow the
procedure below.
From the
A D D I T I O N A L F U N C T I O N S
and set to
S E T T I N G S
O (s) or P (r), and press OK.
For details, refer to "Selecting the Paper Feeding Location (Paper Drawer or Stack
Bypass)." (→ p. 4-2)
2
paper stack (a stack approximately 10 mm high) in the stack bypass.
paper is acceptable.
, select
S T A C K B Y P A S S S I Z E
, then set to
O F F S E T O N L O A D I N G
from
C O M M O N
. Select the paper size using
2
Paper limit guide
2-5