Kurzweil PC3LE6 Musician's Manual page 240

Tutorials: Setup Mode
Assigning A Single Knob To Control Relative Volume In Different Zones
5.
6.
7.
Knob 1 (labeled Timbre on the front panel) should now control the volume of the pad on Zone 2,
222 Class Pad (if not, review the previous steps.)
8.
13-22
On the Controllers page for Zone 2, the Controller field will be highlighted (if not, select the
Controller field with the cursor buttons.) Make sure the LED to the left of the Timbre Knob is lit, if
it is not, press the Shift button to the left of the Knobs until that LED is lit. Next, hold the Enter
button on the alphanumeric pad and move the Knob labeled Timbre. This will select Knob 1 for
the Controller field (see below.) You can also set the desired controller in the Controller field by
using the Alpha Wheel or - / + buttons.
With Knob 1 selected in the Controller field, use the cursor buttons to select the DestType field and
then use the Alpha Wheel or - / + buttons to select Ctrl (see below.)
With Ctrl selected in the DestType field, use the cursor buttons to select the Dest field. In the Dest
field, press 7 and then the Enter button on the alphanumeric pad to choose Volume (see below.)
You can also use the Alpha Wheel or - / + buttons to select a destination in the Dest field.
Next, lets repeat the steps above for Zone 3, except this time we will set a Scale value so that Zone
3 is always quieter than Zone 2. On the Controllers page, use the Chan/Zone buttons to the left of