Kurzweil PC3LE6 Musician's Manual page 263

13. On the controllers page, make sure you are still on zone 5 (the currently selected zone is shown in
the top right corner of the display.) If you are not on zone 5, use the Chan/Zone buttons to the left
of the display to select zone 5. Next, with the Controller field selected on the Controllers page,
hold the Enter button (located with the Category buttons) and press pad 2 (below the display.) This
will select Drum Pad 2 for the Controller field (see below.)
14. With Drum Pad 2 selected for the Controller field on the Controllers page, use the cursor buttons to
select the Type field. With the Type field selected, press the + button (below the Alpha Wheel) to
select Riff (see below.) Now pressing pad 2 should play the horn riff on zone 5.
15. If you press pads 1 and two at the same time, you will notice that the horn riff on pad 2 does not
play at the same tempo as the drum riff on pad 1. The drum riff is playing at the tempo of the setup,
while the horn riff is playing at the tempo of its original sequence, the song 115 Jazz. Lets make the
horn riff play at the tempo of the setup as well. To do this, press the more soft button in the bottom
right corner of the display to find the RIFF2 soft button. Press the RIFF2 soft button to move to the
RIFF2 page. On the RIFF2 page, use the cursor buttons to select the BPM field (in the left column,
bottom of the display.) With the BPM field selected, press the + button (below the Alpha Wheel) to
select Setup (see below.) Now if you press pads 1 and 2 to start the riffs at the same time, their
tempo's should be in sync. Now you can also use the Tap Tempo button (to the left of the display,
below the mode buttons) to set a tempo for the riffs by tapping the button at the desired tempo, or
press the button once to view the Tap Tempo page (see Tap Tempo Button on page 6-4 for details.)
Tutorials: Setup Mode
Basics Of Using Riffs
13-45