The Arpeggiator 1 & 2 Pages (Arp 1, Arp 2); The Program Editor Utility Soft Buttons - Kurzweil PC3LE6 Musician's Manual

Though aux effects Chains are stored for each program, only one channel at a time (the
Note:
currently selected channel) can use its aux effects Chain on the aux bus. Aux effects Chains on
other channels are made inactive.
The ARPEGGIATOR 1 & 2 Pages (ARP 1, ARP 2)
Each program has its own arpeggiator settings. Press the ARP 1 or ARP 2 soft button to go to one
of the two pages of arpeggiator settings for the current program. (You can also view and edit these
settings from the Program mode main page by pressing the Arp Settings button on the front panel, below
the mode buttons.)
See Chapter 7, The ARPEGGIATOR Page for more on these settings. The arpeggiator in Program
mode acts the same as a single arpeggiator does in Setup mode, but in Program mode the
Arpeggiator 2 page has no SyncTo, SyncType, or Num Beats parameters as it does in Setup
mode.

The Program Editor Utility Soft Buttons

Import Arpeggiator Settings (ImpArp)
The ImpArp button allows you to import arpeggiator settings from other programs. Pressing the
ImpArp button brings you to the ImportArp page. On the ImportArp page, select a program
from the list and press the Import soft button to import the arpeggiator settings from the
selected program to the current program.
Delete
This erases a program from memory, freeing up space to store programs in other locations. (You
can check the free memory in the PC3LE at any time, on the top line of the Master mode page.)
Press Delete, and you will be given a choice to Delete or Cancel. Press Delete again, and an "Are
You Sure?" message will appear. Press Yes to delete the setup, or No to cancel.
If you delete a user edited program, there is no way to recover it. If you delete an edited
program that has been saved over a factory ROM ID#, the original factory ROM program will
re-appear. Factory ROM programs can not be deleted.
Program Mode
The Program Editor
6-15