Usb Storage Port; Usb Computer Port - Kurzweil PC3LE6 Musician's Manual

Startup
Startup—the Details
Switching On the Power
The PC3LE's power switch is on the rear panel, adjacent to the power cable connection.
When you power up, the display briefly shows some startup information. The Program mode
display then appears. It looks like the diagram below, though your PC3LE may be different from
the example.
The first time you power up (or after a reset), your instrument will be set to operate on MIDI
Channel 1 (as shown at the far right of the top line above).
Set the volume at a comfortable level. You'll get the best signal-to-noise ratio if you keep the
PC3LE at full volume, and adjust the level from your mixing board. You may also want to adjust
the display contrast by using the small contrast knob on the rear panel of the PC3LE.

USB Storage Port

You can plug a USB mass storage device such as a "thumb drive" into the PC3LE for backing up,
archiving, sharing your work, and updating your software. Any size USB mass storage device
will work, though thumb drives are recommended for their portability, durability, and low
price. The USB Storage port is on the back panel of the PC3LE, but it is easily accessible from the
front of the instrument. A USB connector will only fit into the port if oriented properly, so don't
force it into the port, as this may damage your PC3LE or USB device. If you are having trouble
inserting your USB connector into the port, try flipping the connector over.
Caution: Do not remove a USB device while the display says Loading... or Saving.... Removing a USB
device during a file transfer can cause data corruption.

USB Computer Port

Next to the USB Storage port on the back panel of the PC3LE is a USB Computer port. The USB
Computer port works for MIDI (transmit and receive) or to connect your PC3LE to a computer
for file transfer. By default, the USB port is set to MIDI mode. When selecting USB PC
connection in Storage mode, USB MIDI will temporarily be disabled.
2-4