Temperature Control Cable Adjustment - GMC Chevrolet Camaro 1998 Service Manual

1-104 HVAC System .... Manual
282922
282922
10°- 15°
1
4
3
282915
HVAC
3. Connect the temperature control. cable·toth~
A/C module.
4. Use the following steps in order to install the
temperature control cable to the control:
4.1.
Slip the temperature control cable into
position over the lever arm.
4.2. Aljgli!Jhe shaft with the temperature control
cab.le shaft. ·
4.3.
Press the temperature control· cable dips
into the slot in the control. .
4.4. Ensure that .the temperature control cable
clips are in place. .
5.
Install the temperature control cable bolt.
Tighten
Tighten the temperature control cable bolt to
1.9 N-m (17 lb in).
6. Install the accessory trim plate. Refer to Bezel
Replacement - IP Cluster (Chevrolet) or Bezel
Replacement - IP Cluster (Pontiac) in Instrument
Panel, Gauges and Console.
Te~perature Control Cable Adjustment
Remoyc:11 Pre>cedure,
1.
Remove the right 1/P insulator. Refer to Insulator
Replacement - IP (Right Side) in Instrument .
Panel, Gauges and Console.
2. Remove. the.temper.ature control cable bolt.
3. Disconnect the temperature control cable at the
A/C module.
Important: Ensure that the temperature ·control
cable (3) is still attached to the HVAC control.
4. Cycle the temperature control knob between the
following positions:
• Full cold position
• Full hot position
5.
Replace the t~mperature control cable if one of
the following situations occur:
• The temperature control cable binds
• The temperature control cable does not rotate
freely
Refer to Temperature Control Cable
Replacement.
6. Set the temperature control knob to the detent
position half way between the full cold and the
full hot positions.
(