GMC Chevrolet Camaro 1998 Service Manual page 39

)
)
General Information
65502
10. Secure the cylinder in the J 41340.
10.1. Inspect that the spring retainer is facing up
and positioned directly under the
punch slots.
10.2. Push the cylinder into the J 41340 until
butted with the cylinder bezel.
10.3. Tighten the holding screw.
J 41340
11. Stake the bezel end of the retainer in place:
11.1 . Hold the flat side of the punch, part of
65503
J 41340, squarely against the face of the
cylinder bezel.
11 .2. Stake the lock cylinder metal over the
retainer corners.
General Information 0-27
J
41340
12. Stake the other end of the retainer:
12.1. Remove the punch, part of J 41340.
12.2. Rotate the punch, part of J 41340,
180 degrees.
65504
12.3. Hold the punch, part of J 41340, squarely
against the end of the punch slot oh
J41340.
12.4. Stake. the metal over the other end of the
retainer.
13. Loosen the holding screw.
14. Remove. the cylinder from· the J 41340.
15. Inspect that the retainer is properly staked.
Restake as needed.
16. Lubricate the cylinder retainer slot.
17. Insert the following parts into the cylinder
retainer slot:
• The retainer spring (2)
• The retainer (3)
65505