GMC Chevrolet Camaro 1998 Service Manual page 205

)
)
HVAC
7. Install a new 0-ring seal.
8. Install the accumulator bolt at ,the module.
Tighten
Tighten the accumulator bolt (2) to
16 N,m (12 lb ft).
9.
Install the A/C evaporator bracket.
10. Install the A/C evaporator bracket m~t
(1).
Tighten
Tighten the A/C evaporator bracket nut (1) to
2.0 N,m (18 lb in).
11 .
Position the perforated section of the evaporator
module.
Use epoxy glu~ .in order to adhere the perforated
section to the module.
Allow the epoxy to dry.
12. Use your thumb in order to grade the sealant on
the inside and the outside in order to ensure a
water-tight seal. ·
13. Use the following steps in order to install the
temperature valve case:
13.1. Slide the case upward into position until
the upper clip engages.
13.2. Engage the snap on the left edge of the
temperature valve case to the
distributor case.
14. Install the bolts to the temperature valve
shroud case.
Tighten
Tighten the temperature valve shroud case bolts
to 2.0 N,m (18 lb in).
15.
Install the temperature control cable to the
module.
16. Install the temperature control cable bolt.
Tighten
Tighten the temperature contror cable bolt to
1.9 N,m (17
lb in).
17. Install the heater core. Refer to Heater Core
Replacement.
18. Recharge the A/C system. Refer to Refrigerant
Recovery and Recharging.
19. Refill the cooling system. Refer to Draining and
Filling Cooling System (V6) or Draining and
Filling Cooling System (VB) in Engine Cooling.
HVAC,System - Manual 1-95
282943
282922