Temperature Control Cable Replacement - GMC Chevrolet Camaro 1998 Service Manual

HVAC
Temperature Control Cable Replacement
Removal Procedure
1 . Remove the right 1/P insulator. Refer to Insulator
Replacement - IP (Right Side) in Instrument
Panel, Gauges and Console.
2.
Remove the temperature control cable bolt.
3. Disconnect th.e temperature control cable at, the
A/C
module.
4.
Remove the accessory trim plate. Refer to Bezel
Replacement·- IP Cluster (Chevrolet) or Bezel
Replacement - IP Cluster (Pontiac) in Instrument
Panel, Gauges and Console.
5.
Remove the HVAC control bolts.
6. Pull the HV AC control out of the 1/P far enough to
access the temperature control cable connection.
7. Remove the temperature control cable from the
control.
8. When releasing the control cable clips, use a
small screwdriver to gently pry the cable from
the control.
Installation Procedure
1. Install the temperature control cable to the control.
Notice:
Refer to Fastener Notice in Cautions and
Notices.
2. Install the HVAC control bolts.
Tighten
Tighten the HVAC control bolts to
2.2 N·m (19 lb in).
HVAC System - Manual :1-103
282922
282920