Labels - How To Obtain Replacement; Fasteners - GMC Chevrolet Camaro 1998 Service Manual

0-14 General Information
Camaro/Firebird RPO Table (cont'd)
RPO Description
28U Primary Color Exterior, Navy Blue Met
310
Molding Color Bright Green
31U Primary Color Exterior Bright Green
410 Molding Color Black
41T Top Color Black
41U Primary Color Exterior Black
528 Trim Combination Cloth Lt Neutral
520 Trim Combination Cloth LT Neutral
521 Interior Trim Med Neutral
522 Trim Combination Leather Lt Neutral
523
Trim Combination Leather Med
Neutral II
524 Trim Combination Leather Med Neutral
56T
Top Color Med Dk Neutral
738 Trim Combination Cloth Flame Red
731 Interior Trim Flame Red
790
Molding Color Mystic Teal
79U Primary Color Exterior Mystic Teal
810
Molding Color Bright Red
81U Primary Color Exterior Bright Red
880 Molding Color Bright Purple
88U
Primary Color Exterior Bright Purple
928
Trim Combination Cloth Med Pewter
921 Interior Trim Pewter
960 Molding Color Cayenne Red
96U .
Primary Color Exterior Cayenne
Red Met
General Information
Labels - How to Obtain Replacement
Obtain replacements for the following labels through
the GM Service Parts Operations:
• The vehicle emission control information (exhaust (
emission tune-up) label
• The spare wheel caution label
• The jacking label
• The serpentine belt routing label
• The engine fan caution label
• The spare tire storage label
The following labels are not available as service parts:
• The vehicle certification label
• The tire pressure placard
• The service parts identification label
Fasteners
Metric Fasteners
This vehicle is dimensioned in the metric system. Most
metric fasteners are very close in diameter to well
known fasteners in the English (inch) system. Replace
fasteners with those of the same nominal diameter,
thread pitch, and strength.
A number marking identifies the OE metric fasteners
(except cross-recess head screws). The number
also indicates the strength of the fastener material. A
Posidriv® or Type 1 A cross-recess identifies a
metric cross-recess screw. for best results, use a
Type 1 A cross-recess screwdriver, or equivalent, in
Posidriv® recess head screws.
GM Engineering Standards and North American
Industries have adopted a portion of the ISO-defined
standard metric fastener sizes. The purpose was
to
reduce the number of fastener sizes used while
retaining the best thread qualities in each thread size.
For example, the metric M6.0 X 1 screw, with
nearly the same diameter and 25.4 threads per inch
replaced the English 1/4-20 and 1/4-28 screws.
The thread pitch is midway between the English
coarse and fine thread pitches.