GMC Chevrolet Camaro 1998 Service Manual page 215

)
)
HVAC
7. Inspect the position of the temperature control
cable pulley (2).
Adjust the temperature control cable pulley (2):
• Do not adjust the pulley if the pulley is
skewed
5-10
degrees toward the full cold side.
• Adjust the control cable if the pulley is
skewed toward the full hot side.
8. Remove the spring (4) from the temperature
control cable pulley.
9.
Adjust the temperature control cable pulley
5-10
degrees toward the full cold position;
Installation Procedure
1. Install the temperature control cable spring (4) to
the temperature control cable pulley (2).
2. Connect the temperature control cable (5) to the
heater module.
3.
Connect the temperature control cable to the
AJC
module.
Notice:
Refer to Fastener Notice in Cautions and
Notices.
4. Install the temperature control cable bolt.
Tighten
Tighten the temperature control cable bolt to
1.9 N-m (17 lb in).
5. Install the right
1/P
insulator. Refer to Insulator
Replacement - IP (Right Side) in Instrument
Panel, Gauges and Console.
HVAC System - Manual 1-105
10°- 15°
4
3
282915
282922