GMC Chevrolet Camaro 1998 Service Manual page 204

1-94 HVAC System - Manual
282943
282946
282946
HVAC
6. Remove the bolts from the temperature valve
shroud case.
7. Remove the temperature valve case:
7.1. Slide the case downward to disengage the (
upper case clip'.
7.2.
Remove the valve case from the 1/P.
8.
Use a small hand saw to remove the perforated
section of the HVAC evaporator module. ·
This section will be reused.
9.
Water may leak onto the carpeting when
performing this procedure. Place
a
mat on
the passenger side floor. ·
10.
Remove the A/C evaporator bracket nut
(1).
11 . Remove the A/C evaporator bratket. .
12. Remove the accumulator bolt (2) at the module.
13. Discard the 0-ring seal.
14. Remove the A/C evaporator tube bolt at the
module.
15. Discard the 0-ring seal.
16. Remove the bolts from the A/C evaporator and
blower upper case.
Open the case slightly.
17. Remove the A/C evaporator seaL
18. Remove the evaporator.
19. Transfer the A/C evaporator air filter to the new
evaporatot.
Installation Procedure
1.
Install the A/C evaporator.
2. Install the A/C evaporator seal.
3.
Apply sealer between the evaporator upper and
lower case.
Do not use epoxy glue as a sealer.
Notice: Refer to Fastener Notice in Cautions and
Notices.
4. Install the bolts to the A/C evaporator and blower
upper case.
Tighten
Tighten the A/C evaporator and blower upper
case bolts to 1.8 N-m (16 in).
5.
Install a new 0-ring seal.
6. Install the A/C evaporator tube bolt at the module.
Tighten
Tighten the A/C evaporator tube bolt to
16 N-m (12 lb ft).
(