GMC Chevrolet Camaro 1998 Service Manual page 173

)
)
HVAC
10. With the compressor mounted to the J 34992,
position the rotor and bearing assembly on the
front head.
11. Position the J 33017 and the J 33023-A directly
over the inner race of the bearing.
12. Position the J 8433-1 on the J 33023-A.
13. Assemble the two through bolts and the washers
of the J 34992 through the slots of the J 8433-1.
14. Thread the two through bolts into the J34992.
Ensure that the thread of the through bolts
engages the full thickness of the J 34992;
15. Tighten the J 8433-3 in the J 8433-1 in order to
force the pulley rotor and bearing assembly onto
the front head of the compressor.
16. If the J 33017 slips off direct, in-line contact with
inner face of the bearing, use the following steps:
16.1. Loosen the J 8433-3.
16.2. Realign the J 33017 and the J 33023-A in
order to ensure that the installer clears the
front head.
17. Install the rotor and bearing assembly retainer
ring using the J 6083.
·
18. Install the clutch plate and hub assembly. Refer to
Compressor Clutch Plate/Hub Assembly Install
(VS - Conventional Mount).
HVAC System - Manual 1 ·63
J 8433-1 J 8433-3
237122
237119