Replacement Of Oil Seal - Toshiba e-STUDIO182 Service Manual

(11) Remove the bushing on the rear side.
(12) Remove the oil seal.

(Replacement of Oil seal:

Replacement of Oil Seal")
11.6.8 Replacement of Oil Seal
(1) Insert a fine screwdriver into the depression
of the oil seal to take it out.
(2) Push in a new oil seal parallel to the frame or
bushing (shown figure at right).
(3) Apply the grease (Alvania No.2; amount of 2
rice grains) on entire surface of the oil seal
evenly.
Note:
Wipe off the excessive grease.
e-STUDIO182/212/242
DEVELOPMENT SYSTEM
P.11-20 "11.6.8
Bushing
11 - 20
Oil seal
Fig. 11-36
Inside Outside
Grease
Fig. 11-37
© 2009 TOSHIBA TEC CORPORATION All rights reserved
Oil seal